EVA Foam Grips
The EVA foam grips are light in weight,
more durable than cork, chip resistant, unbreakable, unlike cork. They
are comfortable, soft and warm to the touch. BLACK COLOR ONLY
INSTALLING EVA FOAM GRIPS
EVA grips are easy to install using the
following method. First put the grip onto the blank until it stops; do
not force it down any further. Make a mark on the blank of the bottom
position of the grip closest to the butt. Using an epoxy glue such as
Flex Coat Rod Builders Epoxy Glue apply a generous amount of glue
about 2 inches above your mark and all the way to where the grip will
be in position on the blank closest to the butt. The grip should be
soaked in very hot water and then the grip is pushed from the top to
the correct position on the blank. This can be accomplished using both
hands or by using a push board. After the grip is in the proper
position use epoxy cleaner or acetone to clean off the blank any
excess epoxy. Be very careful not to get any of the cleaning materials
on the label of the blank as it could destroy the label. Use only a
slow cure epoxy glue not a 5 minute glue.


© All Rights Reserved.
Shoff Tackle Co. All graphics water-marked.
|